The A400 and REMORA system support up to 24 FXO/FXS port, and fits with into a PCI-Express port on the motherboard.
Sangoma A400 Key Features
From 2 to 24 ports supported, mixing FXO and FXS interfaces as required.
Support for the Asterisk, Yate, FreeSwitch, OPAL, PBX/IVR projects, as well as other Open Source and proprietary PBX/Switch/IVR/VoIP gateway applications.
Single synchronous PCI interface up to 48 FXO/FXS ports.
The A400 Series is the high density version of the popular A200 seriesanalog cards. Identical in operation and configuration, and using thesame FXO and FXS modules, the A400 system supports twelve ports permain board and REMORA, as compared to four ports for the A200.
If you need to, one additional REMORA card can be added to the basetwelve port A400 card. A single PCI or PCI Express slot host connectioncan support up to 24 FXO/FXS ports with common synchronous clocking forall channels.
Supporting the same total capacity of the A200, the A400 is designed for those specific requirements, where the space might not be available in the PBX case to have upto 5 additional Remora''s like the A200, but the same large capacity is still required.
Like all the Sangoma AFT Series, the A400 and REMORA system has fieldupgradeable firmware to take advantage of enhancements as they becomeavailable. Optionally, the A400 supports Sangoma''s echo cancellationand voice enhancement DSP daughterboard for carrier grade echocancellation and voice enhancement.
Architecture
The A400 consists of an A400 REMORA daughterboard mounted on the AFTPCI /PCI Express. The A400 REMORA card has six sockets each which canaccept an FXO-2 or FXS-2 module. Each FXO-2 or FXS-2 module supportstwo FXO or FXS lines respectively.
Up to one additional A400 REMORA daughterboard can be mounted in emptyslot positions beside the A400 assembly, connected to the A400 by abackplane bus connector. Each 12 port A400 REMORA card is connected bymeans of a standard 12 line color coded telephone cable terminating atthe card in a robust DB25 connector, and ready for hard wiring into apunch block at for the PSTN connection.
Sangoma A400 - Technical Specifications
General Features
From 2 to 24 ports supported, mixing FXO and FXS interfaces as required.
Support for the Asterisk, Yate, FreeSwitch, OPAL, PBX/IVR projects, as well as other Open Source and proprietary PBX/Switch/IVR/VoIP gateway applications.
Single synchronous PCI interface up to 48 FXO/FXS ports.
Connection by means of a standard 2 line colour coded telephone cable for connection to a punch block.
Dimensions: 2U height form factor: 290mm x 55mm for use in a 2U chassis.
Short 2U compatible mounting clips available for installation in 2U rackmount servers.
32 bit bus master DMA data exchanges across PCI interface at 132Mbytes/sec for minimum host processor intervention.
Autosense compatibility with 5v and 3.3v PCI busses.
Fully PCI-Express compliant, compatible with all commercially available motherboards, proper interrupts sharing.
Intelligent hardware:Downloadable Field Programmable Gate Array programming with multiple operating modes. Field upgradeable so that new features related to voice and/or data can be added when they become available.
Power: 800mA peak, operational 300mA max at +3.3v or 5v.
Temperature range: 0 - 50C.
Optional DSP daughterboard on the A400d
G.168-2002 echo cancellation in hardware.
1024 taps/128ms tail per channel on all channel densities.
DTMF decoding and tone recognition.
Voice quality enhancement: Octasic music protection, acoustic echo control and adaptive noise reduction.