Maximize

beroNet BN1E1 Asterisk PCI Card (1 PRI ISDN port)

beroNet BNXE1 PRI ISDN cards offer a powerful and flexible solution for the Open Source PBX Asterisk. Find out more about BeroNets range of PRI and BRI cards at voip.com.vn

More details

Share on Facebook!

Send to a friend

Print

More info
Comments

beroNet BN1E1 Asterisk PCI Card (1 PRI ISDN port)

Write Review

No reviews

This item has been discontinued.

Shipping

Brand beroNet

SKU BN1E1

Availability: Discontinued

Please note that this product has been discontinued. We recommend the beroNet Berofix Gateways as a good alternative.

beroNet BN1E1 Asterisk PCI Card; 1 PRI ISDN port

beroNet BNXE1 PRI ISDN cards offer a powerful and flexible solution for the Open Source PBX Asterisk. Together with the beroNet channeldriver ''chan_mISDN'', which is covered by the GPL licensing agreement, you can easily add PRI ports to your Asterisk system. beroNet''s channel-driver is based on the new ISDN stack of the new Linux Kernel: mISDN (modular ISDN).

The beroNet BNXE1 card series has been developed to complete the Digium PRI product line in case of special scenarios. The BN2E1 has relays for interconnecting both ports if hardware or application is in fail. For ISDN data connections or fax connections through different beroNet cards it is possible to connect the cards through the PCM bus for switching channels in Hardware, so that there is no delay and the transmission of data or fax is assured. A typical use case for this is for example an ISDN data connection to a customer starting from the support pc (BRI) over the ISDN line of the whole company (PRI).

Features

1 or 2 PRI Ports, 30 channels per port
Each port can be configured individually for TE / NT mode
L1, L2, L3 tested (TE-Mode) for compliance to European standards for EuroISDN
Hardware bridging (for transparent voice, data and fax transmission)
PCM Bus (inter-connection between BN cards to enable hardware bridging for different cards via optionalPCM-Bus cable)
Hardware DTMF Detection
ISDN ports are short-circuit protected (by electronic fuse, auto-reset)
BN2E1 has relays for interconnecting Ports if hardware or application is in fault
Line termination (120/75 ohms) is selectable for each port by DIP switch
PCI interface is suitable for 3.3V as well as for 5V PCI 2.2 slots (5V to 3.3V on board regulator)